護坡模具應包裝緊密、整齊。模具應嚴厲入庫檢驗,制止質次或已老化蛻變的份子化合物塑料制品入庫。要包裝緊密、整齊,在出入庫時進行檢查,入庫時要檢驗,制止質量過次或老化的模具進入庫房。堅持庫房的衛生,在墻面和門窗上刷上白色,避免陽光保定平面設計培訓 防撞墻模具 防撞墻模具 防撞護欄模具 大棚遮陽網 遮陰網直射,不能同倉貯存腐蝕性較強的產物。還要注重防潮、防曬、防風、防雨等,還要堅持濕度和溫度,避免護坡模具發作化學反應,招致物理狀況改動。底層庫房要隔離地潮,露天貨垛要做好防曬、防雨、防風、避免露垛。增強模具的庫房溫濕度辦理,份子化合物塑料制品通常需求相宜溫度在27℃以下,相對濕度70%~80。
The slope protection mould shall be packed tightly and neatly. Molds
shall be subject to strict warehousing inspection to prevent inferior or
aging plastic products from warehousing. The packaging shall be tight
and tidy, and the inspection shall be carried out when in and out of the
warehouse. The inspection shall be carried out when in the warehouse to
prevent the molds with poor quality or aging from entering the
warehouse. Adhere to the hygiene of the warehouse, paint white on the
walls, doors and windows to avoid direct sunlight, and do not store
highly corrosive products in the same warehouse. We should also pay
attention to moisture-proof, sunscreen, windproof and rainproof, and
adhere to humidity and temperature to avoid chemical reaction of slope
protection mold and change of physical condition. The warehouse on the
ground floor shall be isolated from the earth tide, and the open-air
cargo stack shall be protected from sun, rain, wind and exposure.
Enhance the warehouse temperature and humidity management of molds.
Molecular compound plastic products usually need appropriate temperature
below 27 ℃ and relative humidity of 70% ~ 80